Operating principle

The operator places the detail in a specially designed slot and closes the door. The machine bases the element in the correct position, seals the connection section and the pressure is applied to the interior. In the first phase of testing, the machine roughly detects the correctness of the element's execution - all elements of the detail (gaskets and O-rings) were fixed on it. When the preliminary test indicates the correctness of the products, the machine starts to check for leaks. Test parameters such as pressure or test time are fully programmable from the control panel. After completing the proper part of the test, based on the pressure drop, the machine analyzes whether the part is hermetic or whether its leakage is within the tolerance specified in the standard. The results of each test are stored on a data carrier and it is possible to later transfer them to another device and further processing. The machine has two chambers, so that during the test, the operator can remove or place the element in the second chamber at the same time. 

Description

The device can be made in various construction versions:

     -     measuring path in a naffow or wide range of pressures

     -     testers in laboratory or process-specific versions can be equipped with an external ATEQ testing module, which test leak tightness with hydrogen or other gases of small particle size. 

Leak tester

Operating principle

The operator loads the pile of pallets onto the loading conveyor, positioning it between side bumpers. The standard length of the conveyor is one stack of pallets. When the device announces the readiness by displaying the appropriate message on the HMI panel, the stack enters the depalletting column and stops on the sensor. The pallet position at the bottom of the stack is checked using an additional inductive sensor. Tower support together with grippers controlled by hydraulic drive goes to the appropriate height set from the operator panel. The pile is gripped and raised to the maximum height, thus freeing the pallet at the very bottom. The transport system transfers the pallet to the rest of the line and stops at the next sensor. In the situation when it is reversed, the pneumatic cords start to operate, which rotate the pallet by 180 degrees, relative to its current position. A correctly stacked pallet is pushed to the second part of the line, after checking if it is empty. The column leaves the stack at the appropriate height, then the grippers open and the cycle repeats until the whole is unloaded. During operation of the tower, the operator has the option of placing another stack on the loading conveyor, which ensures the continuity of the machine's work.

Description

The device can be made in various construction versions:

     -    construction adapted to different transport heights

     -    modular construction on a supprot frame

     -  modular construction with loading transport - different transporter lengths depending on the demand

Depalletizer

Products

Send an inquiry

Leak tester

Depalletizer

  1. pl
  2. en
  3. sr
  1. pl
  2. en
  3. sr
  1. pl
  2. en
  3. sr
  1. pl
  2. en
  3. sr

Opening hours

 

Monday - Friday

8:00 - 16.00

 

Contact

Mateusz Opuchlik

+48 728 446 620

 

biuro@msautomation.pl

Visit us

 

ul. Nowopogońska 98

41 - 250 Czeladź

Poland